A2642NS CA2642NS
A2642DNS CA2642DNS
ADJUSTABLE CART WITH OR WITHOUT CABINET
SINGLE OR DOUBLE PULL OUT SHELVES
Assembly Instructions
Parts List
Qty
1
Part #
Description
022-2813
022-3087
022-1099
022-1252
010-5773
030-1468
030-1470
030-1471
RM1824
Top Section for Single Shelf Models
Top Section for Double Shelf Models
Bottom Section for Open Shelf Models
Bottom Section for Cabinet Models
Notebook Pull Out Shelf (2 for Double Shelf Models)
Left Outer Slide (2 for Double Shelf Models)
Right Outer Slide (2 for Double Shelf Models)
Inner Slides (4 for Double Shelf Models)
18” x 24” Rubber Mat
1
1
1
1
2
1
Casters -
4” Models = (2) 015-0002 w/o Brake & (2) 015-0003 w/Brake
5” Models = (2) 015-0017 w/o Brake & (2) 015-0018 w/Brake
Hardware List
Ref
AA
BB
Qty
4
4
Part #
Description
1/4-20 x 3/4” Combo Screws
1/4-20 Square Nuts
M111 Replacement Key Set
(included with Cabinet Cart Models Only)
030-0253
030-0120
030-0368
1
1
This tab determines where the
shelf will slide out from.
Each cart bracket has additional
cutouts to allow the shelf to pull
out from either side of the cart.
STEP 4
Install the outer slide onto the cart bracket by sliding
TAB 1 into CUTOUT A and TAB 2 into CUTOUT B.
NOTE: Some bend in the bracket is ok as the slides and
shelf will take care of that once they are installed.
IMPORTANT NOTE: Double shelf “DNS” models should have pull
out shelves installed to pull out opposite from one another.
3
STEP 5
Install each inner slide into the outer slides. NOTE:
Push inner slide in all the way until it snaps in.
STEP 6
Extend the slides to the positioning shown.
4
CUTOUT 2
TAB 1
TAB 2
CUTOUT 1
STEP 7
Install the pull out shelf by sliding CUTOUT 1 into TAB 1 and CUTOUT 2 into TAB 2.
Part # 031-7755
Rev. 01.20.11 CZ
5
|