Bosch Appliances Smoke Alarm FMM 7045 Series User Manual

Fire Alarm Systems | FMM-7045 Series Multiplex Addressable Manual Stations  
FMM-7045 Series Multiplex Addressable  
Manual Stations  
Easy addressing with rotary switches  
Low current draw  
Key-lock reset  
Replaceable scored acrylic breakrod option  
Terminal connections  
ADA compliant  
UL Listed  
The FMM-7045 Series Multiplex Manual Stations are UL  
Listed fire alarm initiating devices that can be connected  
along with other multiplex devices on the D7039  
Multiplex Expansion Module. The D7024 Addressable  
Fire Alarm Control Panel (FACP) supervises the entire  
multiplex loop, including the FMM-7045 or FMM-7045-D  
manual stations, for troubles, alarms, and ground fault  
conditions. Because each manual station occupies only  
one address on the multiplex bus, it can be addressed  
for any point within the 9 to 255 range allowed by the  
multiplex expansion module.  
These manual stations are generally installed near  
building exits such as stairways and doors, allowing  
persons evacuating the building to activate the fire  
alarm. They have optional scored acrylic breakrods and  
a pull handle that locks in the activated position, to allow  
easy identification of alarm activation points.  
Functions  
Alarm Action  
The single-action FMM-7045 has a white pull-down lever  
in its center; while the dual-action FMM-7045-D has a  
white push lever above the white pull-down lever in its  
center. Pulling down the pull-down lever latches it into  
place and sends an alarm signal to the control panel over  
the multiplex bus. The pull-down lever cannot be reset  
unless the correct key is inserted into the manual  
station's lock and the unit opened. The latching lever can  
then be restored to its normal position.  
Certifications and Approvals  
Listings and  
Approvals:  
UL UNIU: Boxes, Non-Coded (UL38)  
CSFM: 7150-1615: 122  
These manual stations are high-quality units constructed  
entirely of non-toxic materials. They have a low profile  
and rounded edges to fit most design applications. All  
components are painted or have plated surfaces to  
inhibit corrosion. Non-corroding screw terminals are  
provided for wire connections. They are manufactured  
in conformance with the standards set forth in the  
Americans with Disabilities Act (ADA).  
Complies with:  
Americans with Disabilities Act (ADA 4.28.3)  
National Fire Protection Association (NFPA 72)  
 

Billy Goat Chipper TKD505SPT User Manual
Black Box Computer Monitor SW651ASW652A User Manual
Black Decker Vacuum Cleaner CWV9608 User Manual
Breville Juicer BJS600XL User Manual
Califone DJ Equipment PA10b User Manual
Campbell Manufacturing Switch SDM SW8A User Manual
Carrier Air Conditioner 38ED User Manual
Carrier Furnace 58CTA CTX User Manual
CDA Water Dispenser FWV470 User Manual
Chicago Electric Chainsaw Sharpener 91995 User Manual